Liqui Moly Stoneguard, Gray (Spray) 500ml - 6105

Stoneguard coating based on rubber and resins. Is distinguished by fast drying and ability to be painted over, provides abrasion-resistant corrosion protection, offers excellent protection against stone chipping and has sound-absorbing properties. After drying completely, a permanently elastic film remains. Can be painted over using commercially available paint systems and is easy to grind after drying.

AREAS OF APPLICATION

• As stoneguard and corrosion protection on visible vehicle parts such as sills, rear and front facing panels as well as for chassis and body parts

APPLICATION

• Clean the surfaces to be treated thoroughly in advance and remove rust
• The surfaces must be dry and free of wax, dirt and grease and largely free of dust
• Shake well before use! When the ball has worked loose, continue to shake the can for another minute
• Hold the can vertically when spraying and apply the contents thinly from a distance of about 20 – 30 cm
• The resistance to abrasion and corrosion increases with increasing coating thickness
• For this reason, the spraying process should be repeated once or twice after a short flash-off period
• Should be sprayed using a cross pattern to avoid spray shadowing
• Can be painted over after approx. 60 – 90 min
• (depending on film thickness, temperature and humidity)
• Most of the usual water and solvent-based 2C paints and base coats can be used here
• When using a 2C paint, we recommend using a coat of plastic primer first and painting over this coat after it is completely dry, as recommended by most paint manufacturers
• Recommended application temperature: 15 – 25 °CWe recommend applying thin coats
• Depending on the desired layer thickness, intermediate drying should be carried out after each layer
• If the stoneguard is subsequently painted over, the coats will become increasingly hard
• In other words, the treated surface should be treated accordingly with adhesive primer for plastics in the same way a plastic surface would be

PEAK PERFORMANCE. MAXIMUM PROTECTION

• can be painted over
• colour: grey

ADDITIONAL INFORMATION

• Stoneguard coating based on rubber and resins
• Results in an abrasion-resistant corrosion protection, provides optimum protection against stone chipping and has sound-absorbing properties
• Recommended application temperature: 15 – 25 °CDo not spray material onto moving parts and hot components such as mechanical joints, the engine, gearbox, drive shaft, exhaust pipe, catalytic converter and brake systems
• Shake well before use! After use, the valve of the can should be sprayed empty upside down until only propellant gas escapes!

PROPERTIES

• Very good adhesion on various substrates
• Very good resistance to weathering
• Salt spray and abraded material
• Good stoneguard properties

TECHNICAL DATA