Liqui Moly Liquimate 7700 Mini Rapid Cartridge 50ml - 6126

Two-component polyurethane structural adhesive, fast curing at room temperature, with a very high modulus of elasticity. Suitable for repairing or bonding plastics in vehicle construction as well as in the home and garden and for hobbies.

AREAS OF APPLICATION

• Outstandingly suitable for the repair or bonding of all plastic parts commonly used in vehicle construction as well as the home, for hobbies and gardening (thermoplastics, duroplastics)
• Also suited for the adhesion of broken off parts and for filling holes, tears and joints of metal, wood, stone, concrete or glass
• Chemical resistance:No effect: Water, salt water, oils and greases, acetic acid 10 %, diluted inorganic acids and bases
• Little effect: Aliphatic solvents, gasoline and diesel, water 90 °C
• Destructive effect: Gasoline and diesel, esters, ketones, aromatic hydrocarbons, concentrated acids, chlorinated hydrocarbons
• Substrates:
• Very suitable:Plastics: ABS, PA, PC, PMMA, polyester, PS polystyrene, PUR, PVC hard/softComposites and others: GFRP, carbon, SMC, EPDM, biofiber composites, PP-EPDM, silicon carbides, nitrides, borides
• No test values:Plastics: PBT, PE-HDPE, LDPE, PTEE, PETG, PP, PPE, PPSU, PDCPE, TPOComposites and others: BMC, DMC

APPLICATION

• 1. Clean the parts to be processed thoroughly with water and then dry
• 2. In the event of damage with crack formation, 4 – 5 mm holes must be drilled at each end
• 3. If a painted component is affected, the paint as well as the primer is to be removed on both sides approx. 3 cm around the damaged area
• For non-painted parts, the bonding surface is to be abraded using sandpaper (80 – 120 grain)
• 4. To get enough bonding agent into the repair area to be processed in the event of crack formation, a v-notch should be cut from the outside using a knife
• 5. The area to be processed can be repaired or bonded with adhesive
• The reverse side of the bonding surface is processed first and then the front side
• 6. After approx
• 15 – 30 minutes, the repaired or bonded components can be further processed by grinding, drilling or thread cutting, for example
• Note: Uncured residues of glue can be removed using cleaner and thinner (part no. 6130)
• Cured residues can only be removed by mechanical means
• Wear gloves for processing!

PROPERTIES

• Can be painted over
• Easy to use
• Hardly any loss of material
• High strength
• Rapid curing
• Compatible with liquimate 7700 mini adhesive (part no. 6162)

TECHNICAL DATA